Publicidad
Idiomas disponibles
Idiomas disponibles
screen, now the figure will be flashed at
the end of, showing that the device
entered into self-serviced calibration
mode, and then the user could press
button to adjust this value according to the
error of the device, after the adjustment
finished, to press
time to confirm. The available error range
for adjustment shall be: -7mm~ 7mm.
10. Switch on/off voice
Setup method: After the calibration mode
is set, press continuously the
until the display screen appears
. The flashing
means that user can set up the voice on/
off mode by pressing
button.
means voice on mode.
means voice off mode. After
setting the mode , press
long time to exit.
Note: when switching off the voice
function, the buzzer is off.
Note: User also can press the
the voice on/off mode.
11. Backlight function
Setup method: After the voice mode is set,
press continuously the
display screen appears
. The flashing
EN
button for a long
button
or
or
button for a
to set up
button until the
or
or
means
that user can set up the backlight on/
off mode by pressing
button.
means voice off mode. After
setting the mode, press
long time to exit.
Note: when the backlight function is
on, it will automatically shut off after 10
seconds without any operation.
When the backlight function is off, the
backlight will not on under any operation.
Note: User also can press the
the backlight on/off mode.
or
MEASURING
FUNCTION
1. Distance measurement: single
measurement
While the laser is turned off, to shortly
press
the laser sign
screen, while the laser locked the target
measuring point, to press the
again for the distance measurement in
single time, the measured result data will
be shown on the main displaying area.
2. Distance measurement: continuous
measurement
While the laser is turned on, to press the
means voice on mode.
button to open the laser, then
shall flash on the
or
button for a
to set up
button
21
Publicidad
