Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT CHARACTERISTICS
Pneumatic angle grinder is a tool powered by stream of compressed air. By using grinding wheels, which are mounted on the
spindle, it allows for sanding and cutting of metal. The tool is designed to operate indoors and should not be exposed it to moisture
and precipitation. Correct, reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damages or injuries caused by the tool misuse, resulting from failure to comply with its designation, non compliance with
with safety regulations and recommendations included in this manual, the supplier does not accept any liability. Misuse of the tool
causes also the loss of user's rights to the warranty. as well as in respect of non-compliance with the contract.
EQUIPMENT
The sander is supplied as a complete device, however, before starting work, it should be prepared according to the instructions
given later in this manual. Along with the grinder there are supplied:
- auxiliary handle
-connection to the compressed air installation
- wrenches for installation and removal of grinding wheel
Attention! The grinder is not equipped with grinding wheels.
TECHNICAL DATA
Parameter
Catalog number
Weight
The diameter of the air connection (PT)
The diameter of the air inlet hose (internal)
Thread size of the spindle
Diameter of the grinding wheel
Diameter of the grinding wheel hole
Maximum operation pressure:
Maximum speed
Required air flow (at 0.63 MPa)
Sound pressure (ISO 15744)
Sound pressure (ISO 15744)
Vibration (ISO 28927-1)
GENERAL SAFETY CONDITIONS
WARNING! When you are working with an pneumatic tool, we recommend that you always comply with the basic principles of
occupational safety, including the principles presented below, in order to reduce the risk of fire, electric shock and to prevent
injuries.
Prior to working with the tool, you should read all the instruction and keep it around.
ATTENTION! Read all the instructions below. Failure to comply with them can lead to electrical shock, fire or personal injury. The
concept of "pneumatic tool", which is used in the instructions, refers to all tools, which are driven by a stream of air compressed
at the right pressure.
COMPLY WITH THE FOLLOWING INSTRUCTIONS
General safety conditions
Before starting the installation, work, repair, maintenance and changing of accessories, or when working near pneumatic tool due
to a number of threats, you should read and understand the safety instructions. if the above mentioned steps are not taken, it may
result in serious injury. Installation adjustment and installation of pneumatic tools may be performed only by qualified and trained
staff. Do not modify the pneumatic tool. Modifications can reduce the efficiency and level of security, and increase the risk for a
tool operator. Do not discard the safety instructions, you must pass them to the tool operator. Do not use pneumatic tool, when it
is damaged. The tool should be subject to periodic inspections for visibility of the data required by ISO 11148. The employer/user
should contact the manufacturer for replacement of a rating plate whenever it is necessary.
O R I G I N A L
12
GB
Unit
[kg]
[" / mm]
[" / mm]
-
[mm]
[mm]
[MPa]
[min
-1
]
[l/min]
[dB(A)]
[dB(A)]
[m/s
2
]
I N S T R U C T I O N S
Value
YT-09675
1.7,
6.3 / 1/4
10 / 3/8
M10
125,
16, 22
0.65,
11,000,
141
87 ± 3
98 ± 3
3.4 ± 1.5
Publicidad
