Wesco WS3231 Manual De Instrucciones página 12

The correct power tool will do the job better and
safer at the rate for which it was designed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power
source and/or remove the battery
pack, if detachable, from the power
tool before making any adjustments,
changing accessories, or storing power
tools. Such preventive safety measures reduce the
risk of starting the power tool accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e) Maintain power tools and accessories.
Check for misalignment or binding of
moving parts, breakage of parts and
any other condition that may affect the
power tool's operation. If damaged, have the
power tool repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
h) Keep handles and grasping surfaces
dry, clean and free from oil and grease.
Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in
unexpected situations.
5. SERVICE
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
12
SCREWDRIVER AND
IMPACT WRENCH
SAFETY WARNING
1. Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden
wiring or its own cord. Fasteners contacting
a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully.
1. FITTING AND REMOVING BITS (See Fig. A)
WARNING: Before installing tool,
remove mains plug from mains supply.
Rotate the front section of the chuck to open the jaws.
Insert the drill bit, taking care to ensure the drill bit is in
the centre of the chuck jaws. Rotate the front section
of the chuck in the opposite direction until the drill bit is
firmly clamped.
2. ON/OFF SWITCH (See Fig. B)
Depress the switch to start the tool and release it to stop
your tool.
EN