SNOWJOE sunjoe SPX-EPB1 Manual Del Operador

OPERATOR'S MANUAL
A Division of Snow Joe, LLC
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Always follow these safety guidelines. Failure to do so may
result in serious injury.
General Safety
m
WARNING!
This tool is not intended for use by children
or by unassisted, unsupervised persons whose physical,
sensory or mental capabilities prevent them from using it
safely. Children should be supervised to ensure that they do
not play with the tool.
Before starting up your tool, please check it carefully for any
defects. If you find any, do not start up your tool. Instead,
contact your authorized Snow Joe
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
When using the tool, basic safety
precautions should always be followed to reduce the risk of
electric shock and personal injury. These include:
• Work area – Always inspect the work area for
obstructions or hazards.
• Stay away from power lines – Keep at least 50 feet away
from power lines. Do not touch or aim water at electrical
wiring of any kind.
• Avoid adjustments while in use – Do not extend or
retract the sky lance, change nozzles or accessories while
the tool is in use or under pressure.
• Shut down – Prior to performing any adjustments,
maintenance or when not in use, turn off the pressure
washer, shut off the water supply, point the nozzle in a
safe direction, and pull the trigger to release the water
pressure before making any changes.
• Stay alert – Watch what you are doing. Use common
sense. Do not use the tool on a ladder or scaffolding.
Do not work when you are tired or under the influence of
drugs, alcohol, or other medication.
• Tripping hazard – Keep the high pressure hose clear of
the working area. Avoid stepping or tripping over the hose.
Original instructions.
© 2022 Snow Joe, LLC. All rights reserved.
18 - FT TELESCOPING
R
PRESSURE WASHER SKY LANCE
4200 PSI MAX PRESSURE
Model SPX-EPB1
+ Sun Joe dealer or
® ®
customer service center at
®
• Slipping hazard – Never run while operating the tool.
Maintain proper footing and balance at all times to avoid
slipping or falling. Wear non-slip footwear to improve your
footing on slippery surfaces.
• Avoid unintentional discharge – Do not carry a
connected tool with your hand on the trigger. Make sure
the safety switch is engaged before connecting to the
pressure washer.
• Do not exceed specifications – Do not exceed the
maximum rated pressure, temperature or flow rate listed in
the technical data.
• Inspect the tool – Visually inspect the tool for any loose
fasteners or blocked connections.
1
Form No. SJ-SPX-EPB1-880E-M
SAVE THESE INSTRUCTIONS
EN