K Tool International KTI-XD63228 Manual Del Propietário página 2

This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of the device
owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact
an authorized K-Tool International repair center for replacements. If the operator is not fluent in English, the product and safety instructions shall be
read to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of bottle jacks is subject to certain hazards that cannot be prevented by mechanical means, but only by the exercise of intelligence, care,
and common sense. It is essential to have personnel involved in the use and operation of the jack who are careful, competent, trained, and qualified
in the safe operation of the jack and its proper use when servicing motor vehicles and their components. Examples of hazards are dropping, tipping
or slipping of loads caused primarily by improperly securing loads, overloading, off-centered loads, use on other than hard level surfaces, and using
equipment for a purpose for which it was not intended.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic
fluid or unstable due to loose or missing components. Make corrections before using.
• Lift only at points of the vehicle as specified by the vehicle manufacturer.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Do not exceed rated capacity.
• No persons should be under vehicle when jack is in use.
• This is a lifting device only. Immediately after lifting, support the vehicle with appropriate means.
• No alterations shall be made to this product.
• Use only on a hard level surface capable of supporting load.
• Do not move or dolly vehicle while on jack.
• Always lower the jack slowly and carefully.
• Do not use saddle adaptors or saddle extenders between the stock lifting saddle and the load.
• Center load on saddle. Be sure setup is stable before working on vehicle.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
KTI-XD63228
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
01/13/21