Descargar Imprimir esta página

Sony STR-AZ7000ES Manual De Instrucciones página 3

Ocultar thumbs Ver también para STR-AZ7000ES:

Publicidad

Idiomas disponibles

Idiomas disponibles

If you have any questions about this product:
Visit: https://www.sony.com/electronics/support
Contact: Sony Customer Information Service Center at 1-800-222-7669
Write: Sony Customer Information Service Center 12451 Gateway Blvd.,
Fort Myers, FL 33913
Supplier's Declaration of Conformity
Trade Name: SONY
Model: STR-AZ7000ES/STR-AZ5000ES/STR-AZ3000ES
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego, CA 92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this unit.
This unit must not be co-located or operated in conjunction with any
other antenna or transmitter.
This unit complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines. This unit should be installed and operated keeping
the radiator at least 20 cm or more away from person's body.
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is passed down
through the MAC, through the digital and analog baseband, and finally
to the RF chip. Several special packets are initiated by the MAC. These are
the only ways the digital baseband portion will turn on the RF transmitter,
which it then turns off at the end of the packet. Therefore, the transmitter
will be on only while one of the aforementioned packets is being
transmitted. In other words, this unit shall automatically discontinue
transmission in case of either absence of information to transmit or
operational failure.
Frequency Tolerance: ±20 ppm
For customers in Canada
This unit contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada's licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This unit may not cause interference; and
(2) This unit must accept any interference, including interference that
may cause undesired operation of the unit.
This unit complies with ISED radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the ISED radio frequency
(RF) Exposure rules. This unit should be installed and operated keeping
the radiator at least 20 cm or more away from person's body.
5 150 MHz – 5 350 MHz band is restricted to indoor operations only.
Data transmission is always initiated by software, which is passed down
through the MAC, through the digital and analog baseband, and finally
to the RF chip. Several special packets are initiated by the MAC. These are
the only ways the digital baseband portion will turn on the RF transmitter,
which it then turns off at the end of the packet. Therefore, the transmitter
will be on only while one of the aforementioned packets is being
transmitted. In other words, this unit shall automatically discontinue
transmission in case of either absence of information to transmit or
operational failure.
About recommended cables
Properly shielded and grounded cables and connectors must be used for
connection to host computers and/or peripherals.
3
EN

Publicidad

loading

Este manual también es adecuado para:

Str-az5000esStr-az3000es