EN
EN - USER MANUAL
Portable jump starter, power bank
The auxiliary starter is intended to start cars, boats etc. with
12 V batteries. The built-in battery in the auxiliary starter is
charged with the supplied 230 V charger, which is connected
to the charger port on the auxiliary starter. The auxiliary starter
has a built-in overcharge protection. Two USB ports with 5 V DC
output voltage to charge mobile phone, computer or equivalent.
FEATURES
• Suitable for 12V car emergency start, used to start gasoline
vehicles under 3.5L, diesel vehicles under 2.5L.
• Dual USB 5V 2.4A DC power output interface
• 12V DC output interface, maximum current 10A, continuous
current 8A.
• LED flashlight - 4 working modes.
• Two charging modes:
- USB (Type C) charging input port, charging the product
anytime, anywhere;
- The cigarette lighter charging input (14V DC 1A) can quickly
charge the unit through the cigarette lighter adapter.
• With travel lock function, it is convenient to shut down during
travel to avoid accidentally switch on the device.
• Intelligent LCD display
• Product protection functions: reverse polarity protection,
over current protection, short circuit protection, over charge
protection, reverse charge protection, over discharge
protection, over temperature protection, fire protection.
DEVICE
1. Engine start port
2. Work light
3. USB output
4. USB charging (Type C)
5. Input 14V 1A
6. Output 12V 10A
7. On/Off
8. LCD
TECHNICAL SPECIFICATION
• Jump starter: 400 A, max. 800 A
• Cigarette lighter: 12 V 10 A
• USB port: 5 V 2.4 A
• LED Work lamp: 4 modes
• Lead-acid battery: 4000 mAh (44Wh)
• Voltage: 12 V
• Dimension: 190 x 85 x 28,5 (mm)
• Weight: 0,45kg
• Built-in safety protection
SAFETY INSTRUCTIONS
• The appliance cannot be used instead of the vehicle's
own battery.
• First conned the positive clamp to the positive terminal
on the battery. Then conned the negative clamp to the
negative terminal on the battery, or the vehicle chassis.
2
• Wear safety glasses. Improper use can result in the
risk of personal injury. lf you get battery fluid in your
eyes, rinse your eyes with clean water for at least
10 minutes and then seek immediate medical attention.
• lmproper use of the appliance can result in the risk of
explosion and serious personal injury and/or material
damage.
• When the appliance is not in use it must be in the OFF
position to avoid the risk of personal injury and/or material
damage if the clamps are short-circuited.
• Never short-circuit the clamps with a metal object, or by
allowing them to touch each other.
• Check that the vehicle battery is 12 V.
• Before starting the appliance check that the battery clamps
are connected with the right polarity, otherwise the appliance
or the battery could explode and cause serious injury and/or
material damage.
• Make sure that the vehicle to be started is in a well-ventilated
area.
• Do not expose the appliance to moisture or water.
• Do not take this product a part. Risk of fire, electric shock or
exposure to battery chemicals.
• This is a lithium-ion battery. In the improbable event this
product leaks battery chemicals avoid contact with skin, eyes
or mouth to prevent personal injury or burns. lf your skin
is exposed to battery chemicals, wash with soap and water
and rinse with vinegar. lf you get battery chemicals in your
eyes, rinse immediately with water and then seek medical
attention.
• Charge this product in a well-ventilated a rea.
• Do not smoke or use naked flame near a battery when it is
being charged.
• Never use the auxiliary starter to charge a frozen battery.
• Do not switch the red or black battery clamps after removing
the original battery as this can damage the electronics in the
car.
• Keep the product out of the reach of children.
• Stare the product in a dry and safe place.
• Do not expose the product to temperatures over 70° C or
below minus 20° C.
OPERATION
Charging
Cautions:
• Use the original charger for charging. Unqualified chargers
will shorten the life of the product and may even be
dangerous.
• Charge the unit before using the first time.
• After each use, press the "POWER" button (7). When the
battery level of the LCD screen is 2-3 bars, the device should
be charged ASAP. If with only 1 bar, it should be charged
immediately.
Charging the jump starter:
1. Wall charger: Firstly, connect the charger plug to the 220V
power supply, and then connect the charging output port to the
product input port (5). At this time, the LCD screen displays the
charging status.
2. Car cigarette lighter charging: Connect the cigarette lighter
output plug to the 14V 1A port (5) of the device, and connect
the cigarette lighter to the cigarette lighter port of the car for
charging;
3. USB charging: Use an external USB to connect to the product's
Type C port (4) for charging.