Publicidad
Idiomas disponibles
Idiomas disponibles
DISPLAY
PARAMETERS
iDRY PRESSURE (%)
Pd 70
FLAT ADJUSTMENT
FM
RESETTING
SET.F
OF FACTORY
PARAMETERS
INSPECTION LIST (INSP)
The INSP (Inspection) list allows one to visualise the history of functioning of the inverter, in particular the hours of functioning,
the number of start times, the registration of the alarms.
INSP
WH
TH
NS
SH
E1
E1H
E2
E2H
E3
34
| ENGLISH
DESCRIPTION
Sets the value of the minimum pressure
(expressed as the % of the SET pressure)
which must be reached when there is no
flow as otherwise the dry running alarm
is activated.
Activates/deactivates the FLAT modulation;
the FLAT modulation reduces the heating
of the power components of the inverter
By means of this function the parameters entered in the BASE and ADV lists are
reset at the factory values. ATTENTION: DO NOT USE THIS FUNCTION in the UPV-OS
pumping units as these models have a special setting.
In order to reset the parameters press the SET switch and keep it pressed until "OK"
appears on the display (SET
HOURS OF FUNCTIONING
OF THE PUMP
HOURS INVERTER
SWITCHED ON
TOTAL NUMBER OF
STARTS
AVERAGE NUMBER OF
STARTS
LAST ERROR
HOUR OF LAST ERROR
PENULIMATE ERROR
HOUR OF PENULTIMATE
ERROR
THIRD LAST ERROR
u.m. Default Min
%
-
****
OK)
Hours of functioning of the pump (motor switched on
Hours of functioning (device switched on, with pump
functioning or in STAND-BY)
Number of starts of the pump, from the time of
installation.
Average number of starts each hour the inverter is
switched on
Last error registered
Hour last error registered (referred to TH)
Penultimate error registered
Hour penultimate error registered (referred to TH)
Third last error registered
Max
Step
70
10
100
1
1
0
1
1
Follows
Publicidad
