Publicidad
Idiomas disponibles
Idiomas disponibles
E3H
E4
E4H
EE
TEST
To switch on and regulate the pump manually:
• Enter into TEST mode through access to the HIDDEN LISTS.
• Proceed as shown below to start up and adjust the speed of the pump.
• During the TEST it is possible to display all the operating parameters (through the display of the operating parameters).
INSTRUCTION
INSTRUCTION
TEST mode (the word TEST appears on the display)
TEST mode (the word TEST appears on the display)
Switch on the pump by pressing the OFF/ON switch;
Switch on the pump by pressing the OFF/ON switch;
the pump starts up at the minimum frequency
the pump starts up at the minimum frequency
Display the operating frequency by scrolling with the arrow
Display the operating frequency by scrolling with the arrow
Vary the operating frequency by 1 Hz at a time with the arrows
Vary the operating frequency by 1 Hz at a time with the arrows
Display the operating parameters with the arrows
Display the operating parameters with the arrows
At the end of the TEST switch off the pump by pressing the OFF/ON switch
At the end of the TEST switch off the pump by pressing the OFF/ON switch
HOUR OF THIRD LAST
ERROR
FOURTH LAST ERROR
HOUR OF PENULTIMA
ERROR
ZERO SETTING ERRORS
Hour third last error registered (referred to TH)
Fourth last error registered
Hour fourth last error registered (referred to TH)
Allows one to zero set the errors register; to zero set the
register press the SET button and keep it pressed until
"OK" appears on the display
(SET
****
OK)
DISPLAY
DISPLAY
TEST
P 2.0
F 30
F 35
A 3.5
OFF
ENGLISH |
35
Publicidad
