LiftMaster LMWEKITU Manual De Instrucciones página 2

INSTALL TRANSMITTER BATTERIES AND SET
2
EDGE DIRECTION
1. Open the transmitter housing.
2. Install the batteries. DO NOT let the bottom housing hang by the wires. Energizer
Ultimate Lithium AA L91 batteries are REQUIRED as replacements.
3. Decide the direction (open or closed) the edge will be installed. Set OPEN/CLOSE
DIP switch to match the direction of the edge protection.
OPEN/CLOSE DIP Switches
PROGRAMMING
3
The receiver can learn up to 4 transmitters.
1. Press the learn button on the RECEIVER board. The red LED will come on to
indicate programming mode. NOTE: To exit programming mode, press the learn
button again.
2. Press the learn button on the TRANSMITTER to be learned. The red LED on the
RECEIVER will blink 4 times. If adding an additional TRANSMITTER, press it's learn
button. NOTE: Learn mode times out after 60 seconds if no transmitters are added
or the capacity is reached. After each transmitter is learned there will be an
additional 60 seconds to complete programming.
Learn Button
MOUNT THE RECEIVER
4
IMPORTANT: Disconnect ALL power to the operator.
1. Find the operator diagram on pages 5-7 to see the mounting location for the
receiver.
2. Attach the mounting bracket to the gate operator with the screws provided
(8-32 3/8" or 10-16 3/4").
3. Attach the receiver housing with screws provided.
4. Place the receiver onto the mounting bracket and secure with the 1/4" screw
provided.
5. Reconnect power to the operator.
2 3
OR
5
®
6
4
2
WIRE AND MOUNT THE TRANSMITTER(S)
For best results, install with a clear line of sight between transmitter and operator. The
transmitter can be wired to 1 or 2 edge sensors.
1. Route the wires from the edge sensor into the transmitter. Connect the wires to either
terminal block (polarity is NOT important). The operator will beep once to indicate the
edge sensor has been learned. Apply pressure to edge. The red LED will flash if the
transmitter is wired correctly. Tighten the Heyco connector with 25 in. lbs. of torque
to make transmitter watertight. Use double hole Heyco connector when connecting 2
edge sensors.
2. Attach the mounting bracket to the gate with the screws provided (8-32 3/8" or 10-16
3/4") at least 3.28 ft. (1 m) above the ground. If installing on a round surface, use zip
ties (not provided).
3. Attach the transmitter housing with the screws provided.
4. Place the transmitter onto the mounting bracket and secure with the
1/4" screw provided.
1
Tighten Heyco nut to 25 in. lbs. torque
2 3
≥ 3.28'
(1 m)
4
TEST
Apply pressure to edge. The red LED on the TRANSMITTER and the corresponding
open or close edge LED on the gate operator control board will flash. If the
TRANSMITTER LED does not flash, check the transmitter for proper installation and
wiring, see Transmitter and Receiver Troubleshooting page 4 and check the edge
sensor for proper installation and wiring, see Edge Sensor Troubleshooting page 4.
Status LED
OR