Publicidad
CARDBUS FAST-ETHERNET CARD 10/100 Mbit/s
Introduction
Thank you for purchasing the
Vivanco 10/100 Fast Ethernet Cardbus Adapter. This
Fast Ethernet Adapter allows to connect your notebook to a wired 10 or 100 Mbps
network.
This card is equiped with 2 LEDs indicating the Link/Activity status in 10Mbps or
100Mbps environment.
•
10M LED:
This indicator lights green when the RJ-45 port is connected to a
10Mbps Ethernet network. A flashing green LED indicates that the adapter is sen-
ding or receiving data.
•
100M LED:
This indicator lights green when the RJ-45 port is connected to a
100Mbps Fast Ethernet network. A flashing green LED indicates that the adapter
is sending or receiving data.
General
Standards
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
ANSI/IEEE NWay Auto-Negotiation
32-bit CardBus PC Card
Protocol
CSMA/CD
Data Transfer Rate
Ethernet: 10Mbps (half-duplex)
20Mbps(full-duplex)
Fast Ethernet: 100Mbps (half-duplex)
200Mbps (full-duplex)
Network Cables
10BASE-T: 2-pair UTP Cat. 3,4,5
EIA/TIA- 568 100-ohm STP
100BASE-TX: 2-pair UTP Cat. 5
EIA/TIA- 568 100-ohm STP
Physical and Environmental
Temperature
Operating: 0° ~ 50° C, Storage: -10° ~ 70° C
Humidity
Operating: 10% ~ 90%, Storage: 5% ~ 90%
EMI:
FCC Class B, CE Mark B, VCCI-B
All manuals and user guides at all-guides.com
4
CARDBUS
Hardware Installation
This section describes how to install your
Adapter. Please perform the following steps to install the card.
Card insertion
1.
Find/select an available Type II or Type III 32-bit PC Card slot on your notebook's
side or rear panel.
2. Hold the PC Card with the LED indicator facing up and insert
into the PC Card slot.
3. Slide the PC Card all the way into the PC
Card slot until it reaches a firm stop.
Connect to the Network
Simply plug one end of the cable (RJ-45
tor) into an available hub/switch port, and plug
the other end (RJ-45 connector) into the RJ-45
port of the Vivanco 10/100 Fast Ethernet Cardbus
Adapter.
Card Removal
Use the computer's PC Card Eject mechanism to remove the Fast Ethernet Cardbus
Adapter from the computer's PC Card slot. The Fast Ethernet Cardbus Adapter will
then protrude from the PC Card slot and you can easily remove it by gripping and
withdrawing it from the PC Card receptacle.
Installation of the driver
Windows
®
ME/2000/XP/Server 2003/Vista
Windows will automatically install the drivers for
FAST-ETHERNET CARD 10/100 Mbit/s
Vivanco 10/100 Fast Ethernet Cardbus
connec-
Vivanco Fast Ethernet Card.
5
Publicidad
