DeWalt DXV12P-QTA Manual De Instrucciones página 6

ENGLISH
PRODUCT SPECIFICATIONS
Model
DXV12P-QTA
Tank Capacity
12 Gallon
Power
120 V / 60 Hz / 8 A
Motor Single Stage
Hose
2-1/2 in. x 7 ft.
Power Cord
SJTW18AWG / 20 ft. Length
Noise Level ≤ 65 dB(A)
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SETUP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Assemble the casters, following the instructions
under CASTER ASSEMBLY in this manual.
3. Assemble the accessory bag holder, following
the instructions under ACCESSORY BAG
HOLDER ASSEMBLY in this manual.
4. Attach accessories following the instructions
in this manual.
5. Before replacing power head, refer to this
manual to ensure you have the proper filter
installed for the cleaning operation.
6. Replace power head, and apply pressure
with thumb to each latch until it snaps
tightly in place. Make sure all lid latches are
clamped securely.
7. Insert the hose end into inlet of tank.
8. Attach the extension wands to the end of the
hose. Apply slight pressure until fitting is tight.
9. Attach one of the cleaning accessories
(depending on the cleaning requirements) to
the extension wands. Twist slightly to tighten
the connection.
10. Plug the cord into the wall outlet. The vacuum
is ready for use.
11. To reduce the risk of injury from accidental
starting, always shut off vacuum and
disconnect the power plug from the wall
outlet before installing any part or cleaning
accessory.
WARNING:
Do not alter the plug in any way. If the plug
does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet.
WARNING:
To reduce the risk of fire or explosion, do not
operate this vac in areas with flammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter fluid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited
to: coal, magnesium, aluminum, and grain or
gun powder. Do not vacuum explosive dust,
flammable or combustible liquids or hot ashes.
Do not use this vac as a sprayer for any
flammable or combustible liquid. To reduce
the risk of health hazards from vapors or
dusts, do not vacuum toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
CASTER ASSEMBLY
1. Invert dust tank, take the caster to align the
tank bottom sinking place. Secure with
screws provided.
2. Return dust tank assembly upright.
ACCESSORY BAG HOLDER
ASSEMBLY
Attach 2 accessory bag holder brackets to
tank with 4 self-tapping screws provided.
Place the accessory bag holder into the hole
of bracket. (See illustration).
4