Descargar Imprimir esta página

DeWalt DXV12P-QTA Manual De Instrucciones página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
INSTALLING THE DISPOSABLE
FILTER BAG
1. Slide the cardboard collar opening firmly onto
the vacuum port deflector until it stops against
the deflector wall.
2. Position the bag so that it is distributed around
the inside of the tank.
3. Replace and secure the power head onto the
tank.
WET PICK-UP
The cartridge filter must be positioned over the
filter cage while vacuuming liquids. When
picking up several tanks full of liquid, the
cartridge filter will become saturated and misting
may appear in the exhaust air. At this time, the
should dry or replace the cartridge filter to
eliminate the misting and possible dripping of
liquid around the lid. After completing a wet
pick-up job, raise the hose to drain any excess
liquid into the tank before shutting off. The
interior of tank should be periodically cleaned.
1. Always disconnect the plug from the wall outlet
before removing the power head. Place power
head in an upside down position. Remove the
cartridge filter by sliding it up and off the
filter cage.
2. Shake excess dust off the cartridge filter with
a rapid up and down movement.
NOTE: WET PICK-UP ACCESSORIES
SHOULD BE WASHED PERIODICALLY,
ESPECIALLY AFTER PICKING UP WET,
STICKY FLUIDS OR SPILLS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION
OF SOAP AND WATER.
3. This wet/dry vac is equipped with a float
Disposable
filter bag
6
mechanism which will rise automatically to
cut off the airflow when the liquid in the tank
reaches a predetermined level. When this
happens, turn off vac, unplug the power cord,
and empty the dust tank. You will know that
the float has shut the airflow off because the
suction ceases and the motor noise becomes
higher in pitch due to increased motor speed.
The liquid capacity may vary with the
rate of pickup.
IMPORTANT: To reduce the risk of damage
to the vac, do not run motor with float in
raised position.
Float in raised
position
NOTE: IF ACCIDENTALLY TIPPED OVER,
THE VACUUM COULD LOSE SUCTION. IF
THIS OCCURS, PLACE VAC IN UPRIGHT
POSITION AND TURN SWITCH OFF. THIS
WILL ALLOW THE FLOAT TO RETURN TO
ITS NORMAL POSITION, AND YOU WILL BE
ABLE TO CONTINUE OPERATION.
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before emptying
the dust tank.
1. Remove the power head assembly of the
wet/dry vac by pulling outward on the lid
latch located on each side of the vac.
Lift off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
3. Liquids may be emptied through the tank
drain. To empty, turn the unit off and
remove the plug from the wall outlet.
Remove the drain cap and deposit the
liquid waste contents in a suitable drain.
After tank is empty, return the drain cap
to its original position. To continue use,
plug the cord into the wall outlet and
turn the unit on.

Publicidad

loading