Publicidad
Idiomas disponibles
Idiomas disponibles
Issue
Image appears blurred,
indistinct, or too dark.
"Check Video Cable" is
displayed on the screen.
"Input Signal Out of
Range" is displayed on
screen.
The monitor does not
enter into a low-power
sleep state.
"OSD Lockout" is
displayed.
"Power Button Lockout" is
displayed.
Button lockouts
The button lockout function is available only when the monitor is on, an active signal is displayed, and
the OSD menu is closed. Holding down the power button or Menu button for 10 seconds disables that
button. You can re-enable the button by holding it down again for 10 seconds.
Questions or Setup Issues?
Contact the HyperX support team at: hyperx.gg/support.
Possible cause
Brightness setting is too low.
Monitor video cable is
disconnected.
Video resolution and/or refresh
rate are set higher than the
monitor supports.
The monitor's power saving
control is disabled.
The monitor's OSD Lockout
function is enabled.
The monitor's Power Button
Lockout feature is enabled.
HyperX Armada 25 FHD Gaming Monitor
Solution
Open the OSD menu and select Color
to adjust the brightness scale as
needed.
Connect the appropriate video signal
cable between the computer and
monitor. Be sure that the computer
power is off while connecting the
video cable.
Change the settings to a supported
setting.
Open the OSD menu and select
Power, select Auto-Sleep Mode, and
then set auto-sleep to On.
Press and hold the center of the
joystick control button for 10 seconds
to disable the OSD Lockout function.
Press and hold the Power button for
10 seconds to unlock the power
button function.
Page 25 of 29
Publicidad
