Publicidad
Idiomas disponibles
Idiomas disponibles
Solving common issues
The following table lists possible issues, the possible cause of each issue, and the recommended
solutions.
HyperX Armada 27 QHD Gaming Monitor
Issue
Screen is blank or video is
blinking.
Image appears blurred,
indistinct, or too dark.
"Check Video Cable" is
displayed on the screen.
"Input Signal Out of
Range" is displayed on
screen.
The monitor does not
enter into a low-power
sleep state.
Possible cause
Power cord is disconnected.
Monitor is off.
Video cable is improperly
connected.
Brightness setting is too low.
Monitor video cable is
disconnected.
Video resolution and/or refresh
rate are set higher than the
monitor supports.
The monitor's power saving
control is disabled.
HyperX Armada 27 QHD Gaming Monitor
Solution
Connect the power cord.
Press the power button.
Connect the video cable properly.
Open the OSD menu and select the
Input menu. Set Auto-Switch Input to
Off and manually select the input.
or
Replace the video card or connect
the video cable to one of the
computer's on-board video sources.
Open the OSD menu and select Color
to adjust the brightness scale as
needed.
Connect the appropriate video signal
cable between the computer and
monitor. Be sure that the computer
power is off while connecting the
video cable.
Change the settings to a supported
setting.
Open the OSD menu and select
Power, select Auto-Sleep Mode, and
then set auto-sleep to On.
Page 24 of 29
Publicidad
