Aesculap FAV5 CL Instrucciones De Manejo página 9

4.1.3 Attach the adapter to the power sup-
ply of the charger
The adapter for EU countries is installed on the power
supply of the charger at the factory.
Note
The USA adapter is integrated into the power supply.
The USA adapter can be folded out if no other adapter
is installed on the power supply.
14
15
18
Fig. 3
Remove EU/UK/AUS from the power supply.
Loosen the fixation screw 18 in adapter 15, see
Fig. .
Press the lock release 16 and remove the
adapter 15 from the power supply.
Install the EU/UK/AUS adapter on the power supply
Push the adapter 15 onto the power supply 14
until the lock 16 clicks into place, see Fig. .
Screw the fixation screw 18 Screw the fixation
screw 15.
4.1.4 Connecting the charger/Charging the
Li-ion battery
Fire hazard due to battery poles
shorted by fluids or metal compo-
nents!
WARNING Do not short the Li-ion battery.
WARNING
CAUTION
14
15
CAUTION
Note
Switch off the battery-powered clipping machine
FAV5 CL/FORTIS before charging!
Note
Li-ion batteries heat up slightly during charging.
Note
Unplug the mains power cord at the mains socket when
the charger is not going to be used!
To connect charger 4: Plug in the device plug of
mains power cord 5 in charger 4.
Plug in the mains plug of mains power cord 5 at
the mains power socket.
Risk of injury and material damage
due to damaged Li-ion batteries!
Prior to charging, check the Li-
ion batteries for any damage.
Do not use or charge damaged
Li-ion batteries.
Loss of capacity/performance due
to prolonged storage of discharged
Li-ion batteries!
Store Li-ion batteries only in
fully charged condition and
recharge stored batteries once
every month.
Destruction of the product, charg-
ing bay or Li-ion battery when
inserting the wrong type of battery
in the charging bay!
Insert Li-ion batteries only in
the appropriate charging bay.
Insert the Li-ion battery in the
correct position.
7