Fein CCG18-115-10 AS Manual De Instrucciones página 33

Declaration of conformity.
This CE declaration is only valid for European Union
and EFTA (European Free Trade Association) countries
and only for products intended for the EU or EFTA
market. After placing the product on the EU market the
UKCA mark loses its mark validity.
The UKCA declaration is only valid for the Great
Britain market (England, Wales and Scotland) and only
for products intended for the Great Britain market.
After placing the product on the Great Britain market
the CE mark loses its mark validity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the
last page of this Instruction Manual.
Technical documents at:
C. & E. Fein GmbH
Hans-Fein-Straße 81
73529 Schwäbisch Gmünd-Bargau, Germany
Environmental protection, disposal.
Do not dispose of the batteries into household-
waste!
Packaging, worn out power tools and accessories
should be sorted for environmental-friendly recycling.
Dispose of batteries only when discharged.
For batteries that are not completely discharged, insu-
late the terminals with tape as a protective measure
against short-circuiting.
Only for EC countries:
According to the European Guideline 2002/66/EC,
defective or used battery packs/batteries, must be col-
lected separately and disposed of in an environmental-
lycorrect manner.
Selection of accessories (see
pages 15/16).
Use only original FEIN accessories. The accessories
must be intended for the power tool type.
A-1 Wheel guard for cutting, type A
B-1 Wheel guard for grinding, type B
B-3 Safety cover for cutting
1-1 Grinding disc, type 27
2-1 Cutting disc
(use only with mounted safety cover)
3-1 Flap discs
3-2 Backing pad for fibre sanding sheets, fibre sanding
sheets
(mount only with the provided backing-pad clamp-
ing unit)
3-3 Backing pad with Velcro, Velcro sanding sheets,
sanding fleece with Velcro attachment, sponges
(use a fitting open-end spanner)
4-1 Steel tapered twist brush
4-2 Steel-wire cup brush, flap discs
(use a fitting open-end spanner)
5-1 Diamond hole cutter
(use fitting open-end spanner)
en
33