Publicidad
Idiomas disponibles
Idiomas disponibles
5. Lay the support bars across
both legs, parallel to the
handles on the seat bench
(Figure 2A). Secure each
end of the support bar to the
pertinent leg with a long screw
(Figure 2B). NOTE: Do NOT
use the bath seat without the
support bars.
6. Insert each leg into a leg frame by depressing the
pushpins (Figure 3A and 3B). Slide the leg frames
over the leg and setting to the same desired height
(Figure 3C).
Adjusting Leg Height
1. On each leg, depress the push button and slide to
desired height by aligning with a hole (Figure 3B).
Let the push button snap into a hole to lock the leg in
place (Figure 3C).
2. Check that the legs are locked in place by pushing
down and pulling up on each leg.
CAUTIONS:
* Inspect all parts for possible damage before
assembling. If there is any damage – DO NOT USE.
Contact Medline at 1-800-MEDLINE.
* Check that the height adjusting pushbuttons fully
protrude through the same corresponding hole of each
leg extension. This ensures that the leg extensions are
securely locked in place at an even height.
* Make sure all screws, nuts and bolts are tightened.
* Verify that all tips are in place on the leg extensions and
not ripped, worn or missing. Replace any missing or
damaged tips.
* The tips of all four leg extensions MUST touch the floor
simultaneously at all times.
* Do NOT stand on the bath seat.
* Do NOT exceed the user weight capacity of 400 lbs (181 kg).
* Do NOT place bath seat on uneven surfaces.
* Do NOT use if wobbly, unstable or not level.
Figure 3
G2-201KRX1
REVISED: V1 121422
Publicidad
