Publicidad
Idiomas disponibles
Idiomas disponibles
The indicator inside the DC circuit protector button will pop out to show that the DC circuit:
protector has switched off. Wait a few minutes and push the button in Io reset the DC circuit
protector.
Connecting the batter/ cables:
①. Before connecting charging cables to a battery that is installed in a vehicle
Disconnect the vehicle's grounded battery cable.
WARNING!
The battery gives off explosive gases; keep Bparh1 flames
and cigarettes away， Provide adequate ventilation when
charging causing batteries.
②. Connect the positive (+) battery cable to the battery positive (+) terminal.
③. Connect the other end of the positive(+) battery cable to the generator
④. Connect the negative (-) battery cable to the battery negative (-) terminal.
⑤. Connect the other end of the negative(-) battery cable to the generator
⑥. Start the generator.
NOTICE!
Do not start the vehicle while the battery charging cables are connected and the generator is
running. The vehicle or the generator may be damaged.
An overloaded DC circuit will fuse the DC fuse, if this happens, replace fuse.
An overloaded DC, excessive current draw by the battery, or a wiring problem will trip the DC circuit
protector (PUSH button extends out). If this happens, wait a few minutes before pushing in the
circuit protector to resume operation. If the circuit protector continues to go OFF. discontinue
changing and see your authorized generator dealer.
Disconnecting the battery cables:
①. Stop the engine,
②. Disconnect the negative (-) battery cable from the generator negative (-)terminal.
③. Disconnect the other end of the negative (-) battery cable from the battery negative (-)terminal.
④. Disconnect the positive(+) battery cable from the generator positive (+)terminal,
⑤. Disconnect the other end of the positive(+)battery cable to the battery positive(+) terminal.
⑥. Connect the vehicle ground cable Io battery negative (-) terminal.
9
Publicidad
