Hansgrohe Raindance Select S 240 2jet Showerpipe 271291 Serie Instrucciones De Montaje / Manejo / Garantía página 2

English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
Installation Considerations
• This showerpipe is for use with shower heads rated
at 2.5 GPM (9.5 l/min) or higher.
• For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The installation dimensions shown in this installation
instruction are ideal for people of approximately
6' in height. The dimensions can be changed if
required. In this case, the minimum ceiling height
of 87¾" from the standing surface, and all other
measurements, must be changed.
• Make sure that the wall is strong enough to support
the showerpipe. Hansgrohe strongly suggests instal-
lation of a header at the top mounting point.
Tools Required / Outiles Utiles /
Herramientas Útiles
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.5 GPM max.
2.5 GPM max.
8 mm
24 mm
30 mm
¼" / 6 mm
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
• The area where the top mounting piece is to be
installed must be flat and free of protruding grout
joints, etc.
• The enclosed screws and anchors are suitable for a
solid surface wall. For other wall constructions, se-
lect mounting hardware and reinforcement suitable
for that specific construction.
• This showerpipe requires showerpipe rough
16181181(not included).
• To prevent scald injury, the maximum output
temperature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.