Black and Decker PRO Serie Manual De Instrucciones página 41

ASSEMBLING STAND
1. Assemble the stand as shown in Fig. 4C, using 16 M8x1.25x20mm carriage head bolts, 3/8"
flat washers and M8x1.25 hex nuts. Align the holes in the stand legs (F) with the holes in the
brackets. Insert the carriage head bolt through the hole in the leg and the hole in the bracket,
place a flat washer on the carriage head bolt and thread a hex nut onto the carriage head bolt.
Repeat this process for the 15 remaining holes in the legs and brackets.
NOTE: Loosely tighten the hardware for further adjustment.
Letters are on the stand brackets to ease assembly:
A - Top front and rear brackets
B - Top side brackets
C - Bottom side brackets
D - Bottom front and rear brackets
2. Attach the rubber feet (E) Fig. 4C to the bottom of each leg (F).
SAW TO STAND
1. Turn saw table face down on a piece of cardboard to protect the table surface. Place stand
upside down onto saw and align the four holes in the stand with the mounting holes in the saw.
2. Place a 3/8" flat washer on a M8x1.25x45mm hex head screw. Insert the hex head screw
through the mounting hole in the saw and the mounting hole in the stand. Place another 3/8" flat
washer on the hex head screw and thread a M8x1.25 hex nut on the screw and loosely tighten.
Complete this process for the other three holes.
3. Stand the saw upright, as shown in Fig. 4D (Saw is shown fully assembled here).
4. Push down on top of the saw so that the legs of the stand adjust to the surface of the floor.
Tighten all hardware securely.
ASSEMBLING BLADE RAISING AND LOWERING
HANDWHEEL
1. Insert special screw (C) through handle (B) Fig.5 and assembly handle to handwheel (A) by
threading screw clockwise into handwheel. Then push on handle cover (D).
2. Fig. 6, illustrates the handle (B) assembled to handwheel (A).
3. Assemble handwheel (A) Fig. 7, to shaft (B) making sure the flat on inside of handwheel lines up
with flat on shaft.
4. Fasten handwheel (A) Fig. 8, to shaft (B) Fig. 7, using a M6x1x12mm flat head screw (C) Fig. 8.
A
Fig. 7
All manuals and user guides at all-guides.com
B
41
A
C
D
Fig. 4C
Fig. 4D
A
B
Fig. 5
Fig. 6
C
Fig. 8
B
F
E
C
D
A