SPC CONFORTO DC LITE 2 Manual De Usuario página 27

10. Due to the movement of the fan, some fasteners may loosen. Check all
fasteners at least twice a year to make sure they are properly tightened. If
necessary, they must be tightened again.
11. If the power cord is damaged, it must be replaced by the manufacturer, its
after-sales service or similar qualified personnel, in order to avoid danger.
12. The light fitting should only be replaced by an original supplied by the man-
ufacturer.
INSTALLATION
Note: This product should only be installed by licensed electricians.
Take out all of the components. Place the motor on a cloth or soft surface to
avoid damaging its finish.
Handle the assembly carefully to avoid bending or scratching its case.
The fan should be assembled on the floor or on a table large enough so that no
components fall.
Do not lift or carry the fan by the cables.
REQUIRED TOOLS
27
EN