Publicidad
Idiomas disponibles
Idiomas disponibles
GB
1.
Aerial
2.
Baby unit on/off switch
3.
Parent unit on/off switch
4.
Baby unit power led / green
Low battery or out of range signalling led / orange
5.
Parent unit power led / green
Low battery or out of range signalling led / orange
6.
Volume level indicator led
7.
Speaker
8.
Belt clip
9.
Parent unit volume control
10.
Mains power adapter socket
11.
On/off switch – reset
1.
6.
9.
5.
7.
3.
10.
1.
4.
3.
10.
2
Electronic baby monitor
8.
11.
11.
BabyOno electronic monitor is a portable monitoring system.
•
Wireless, digital transmission 2.4GHz
•
High sensitivity
•
Stand-by (VOX) energy saving mode
•
Alkaline batteries AAA 6x1.5V (optional)
•
Mains power adapters included (2 pieces)
•
Range up to 300 meters in open space
•
Belt-clip to carry the monitor around the house
•
32 channels ensuring disturbance-free operation
(FHSS).
INSTALLATION
Place the baby unit app. 1 meter away from the child. Con-
nect the mains power adapter to the baby unit adapter socket
or install the batteries (3 x 1.5V AAA). Switch on the unit by
turning the ON/OFF knob upwards. The power LED will turn
green. Connect the mains power adapter to the parent unit
adapter socket or install the batteries (3 x 1.5V AAA). The
LEDs indicate volume intensity. The volume may be adjusted
by using the +/- regulator.
HOW TO RESET THE DEVICE:
The baby and parent units are paired by the manufacturer.
Resetting the device should be performed as a last resort,
when there is no connection between the units. Connect the
mains power adapters to the baby and parent units. Switch
on both the devices. Use a needle to press and hold the Reset
button located under the battery compartment cover of the
baby / parent units. Release the Reset button after 1 second.
Both the devices are now switched off and reset. Next, switch
on the units.
HOW TO EXCHANGE THE BATTERIES - 6 x 1.5A (AAA)
1.
Unscrew the battery compartment cover and place
the batteries as indicated (pole marking).
2.
Place the cover in its original position, screw it down
and make sure it has been properly mounted.
3.
Switch on the device and check if the LED has turned
Publicidad
