Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
• Please do NOT damage the power cord or plug.
• Please do NOT forcefully throw, stretch, twist, bend, machine, heat, process, bind, or clamp
power cords or inlet water hoses or put heavy things on them.
• Please use power outlets and wiring tools within the defined scope. Heat and fire may result
if wiring outside the defined scope of the power outlet.
• Please do NOT use any power supply other than those designated (AC 120V, 50-60Hz), or
fire or heat may be caused.
• Please do NOT put fingers or other objects into the warm air outlet or block it.
• Please do NOT cover the air outlet with any object or clothes. Otherwise burns, electric
shock or parts burn-out may occur.
• Please do NOT approach the product with cigarettes or other kindling, as fire may occur.
• Non-rechargeable batteries are not to be recharged.
• Caution: Low temperature burns. If not used properly, heated seats may cause low
temperature burns. Therefore, if sitting on the seat for a long period of time, please set the
seat temperature adjustment to "off".
• For the persons or circumstances below, please set temperature adjustment of both the seat
and the warm air to "off".
• Children, the elderly, or others who cannot adjust temperature to an appropriate level.
• The sick, disabled or others with restricted mobility.
• Lethargic people who have taken medicines with hypnotic effects (such as sleeping pills
and medicine for colds), intoxicated or fatigued.
• As this is an electrical product, please do NOT install it at any place exposed to water splash
or with high humidity.
• A ventilation fan must be available to maintain good indoor ventilation, otherwise fire or
electric shock may occur.
• This product must be connected to a cold-water pipe. Otherwise personal burns or product
failure may occur.
• Please ensure correct grounding with a GFCI electrical outlet connection. If product is not
properly grounded, electric shock may occur.
• Proper grounding is ground resistance below 100Ω and copper wire over 1.5mm in diameter
as the distribution panel grounding wire. (*Please ask an installation professional to install
the grounding wire.)
• Make sure the power outlet used is correctly grounded (triplex receptacle outlet). Otherwise
electric shock may occur due to faults or short circuit.
• Outlets for power supply wiring must be configured as follows: Otherwise fire or electric
shock may occur.
• 1. Please use high sensitivity and rapid type residual current circuit breakers (with
rated induction current below 15mA) or insulated transformers (above 1.5kVA, below
3kVA) in the socket circuit for protection.
• 2. According to relevant national regulations, ensure socket fitting location in advance
and make it as far away from the bathtub as possible.
• *Please make sure wiring work in the above 1. and 2. is finished, or please ask a
professional contractor to perform the wiring.
• Please make sure to insert the power plug firmly into the outlet. Otherwise, fire, heat or short
circuit may occur.
• When pulling out the power plug, please hold the power plug not the cord. (Please do NOT
pull out the power plug by grabbing the cord). Otherwise, fire or heat may occur due to
power cord damage.
FORBIDDEN ACTIONS
MANDATORY ACTIONS
6
Publicidad
