Cleco BD Serie Manual De Instrucciones página 4

1
1
EN
EN 1 EN
1 About this document
This document is intended for specialists in installation
and maintenance (administrators, fitters, maintenance
staff, service personnel, owners/operators).
It contains information on using the component.
Note
Risk of injury/property damage
This document does not provide sufficient in-
formation on the replacement/installation of
the component in the spindle. Faulty installa-
tion can influence the calibration values or
the rundown result. Faulty rundown results
can lead to displacements and/or material
damage.
► Only replace the component after the
safety notes in the installation instruc-
tions and maintenance instructions have
been read and fully understood.
Note
Loss of warranty
Repairs may only be carried out by person-
nel authorized by Apex Tool Group.
► In case of repair, send the complete
component to Sales & Service Center!
Other documents
Number Document
P2182BA Operating Instructions - 961502PT
Transducer Service Interface
P2578WA Maintenance instruction – Fixtured
Spindle BD Series
P2579MA Assembly instructions – Fixtured Spin-
dle BD Series
2 Product Description
Digital transducer for recording torque and turning angle.
Use only as a component of a spindle of the BD/BTSi se-
ries.
Transducer
Code Capacity
Nm
1K1D 35
1K2D 60
1K3D 12
2K1D 110
2K3D 200
3K2D 300
4K1D 400
4K2D 500
4K3D 660
4
Replacing the cable
The transducer (...)K(...)D is supplied with a fixed cable in
a standard length. This length fits most applications, but
can be extended or completely replaced if required.
Fig. 1-1: Replacing the cable
Cable length
[mm]
250
350
450
550
650
Order No.
942610PT
942611PT
942612PT
942620PT
942622PT
942631PT
942640PT
942641PT
942642PT
P2582PL | 2022-08
Order No.
942769PT-002
942769PT-003
942769PT-004
942769PT-005
942769PT-006
Apex Tool Group