HOMCOM 800-063V70 Manual Del Usuario página 7

UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check if ice basket and ice scoop inside. If
any parts are missing, please contact our customer service.
2. Remove the tapes for fixing ice shovel, ice basket & ice scoop. Clean the tank & ice
basket.
3. Put the ice maker on a level & flat counter top without direct sunlight and other sources of
heat (i.e.: stove, furnace, radiator). Make sure that there is at least 4 inches gap between
the back & LH/RH sides with the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging the ice maker in.
5. The appliance must be positioned so that the plug is accessible.
WARNING: fill with potable water only. Only use drinking water.
CONNECTING YOUR ICE MAKER
*Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not
under any circumstances, cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good
grounding means.
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water by unplugging
the drain cap on front bottom side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent
solution and warm water.
5. Dry the interior and exterior with a clean soft cloth.
6. When the machine is not to be used for a long time, drain water completely & dry the
interior.
USING YOUR ICE MAKER
1. Open the cover, remove the ice basket and pour water into tank. Keep water level below
the water level mark.
2. Press "ON/OFF" button on the control panel to begin the ice making cycle.
3. Select the ice cube size by pressing the "SELECT" button. If the room temperature is
lower than 15℃(59℉), it is recommended to select small ice cube in order to avoid ice
sticking together.
4. The ice making cycle lasts approx. 6 to 13 minutes, depending on selection of ice cube
size and the room temperature. The recommended room temperature is 10℃ to 38℃
(50 ℉ to 100 ℉)
!
DANGER
7