Publicidad
Idiomas disponibles
Idiomas disponibles
• The normal operating voltage of this device is 9 volts. If the batteries become flat,
a continuous tone will sound. If the ultra-high sound becomes clearly audible and
changes to a continuous tone. Change the batteries. The operating time with fresh
batteries is about 8 months.
• The enclosed adapter cable is not needed. Please close the plug socket with the plug
provided.
Installing in the car:
• The device is assembled in the engine compartment of the car. It should be installed
in a place in the engine compartment that is protected from splash water and gener-
al dirt. Make sure that the LED Flash function is not covered.
• The device is connected directly to the car battery. Plug the adapter cable into the
device. The plug must be inserted into the socket with a twisting movement as far as
it will go, so that a firm hold is guaranteed, and the housing is sealed. The red cable
is connected to the positive pole, the brown cable to the negative pole.
• Should your car no longer be in for a long time Operation, please make sure that the
appliance is in this period is disconnected or switched off.
Application:
• Unwanted visits by martens on your premises will be intrusions of the past. The Gar-
digo Anti-Marten Dual keeps the biting pests away from the car, house, garage, barn,
loft or gazebo with ultrasonic noise at regular intervals. The device is ready to go and
no power connection nor installation is required. The device emits high frequency
sounds at intervals of 30 seconds. These sounds, barely perceptible to the human
ear, keep the martens away from vehicles and areas. The integrated interval circuit
also prevents the animal from getting accustomed to the sound.
• An integrated vibration sensor detects whether the device is being moved or if it is
at a standstill and switches on or off accordingly. At a standstill, when e.g. the car is
parked, the device is active and transmits. Whilst driving, the device switches off and
saves battery.
• An installation in vehicles, is possible with the supplied cable ties. For attachment
outside the vehicle, screws are also available. Secure the unit to a suitable location in
the engine compartment or on walls, fences or similar surfaces in the home, garden
or barn with screws or the supplied cable ties. When mounting on a wall, make sure
that there is a no area at the bottom of the wall, which is not covered by the sound.
• When the vehicle is stationary, the device switches on automatically after approx. 60
seconds, or switches off vibrations generated by the motor or during driving (auto-
matic switch-off). The device is only active when the vehicle is parked. This protects
the car battery (Auto-ON-OFF).
9
Publicidad
