Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Installing and changing blades
Always wear protective gloves when changing blades.
The blades should always be sharpened or replaced at
the same time. Otherwise, the appliance will become
unbalanced which will cause vibrations and decrease the
electric planer's lifespan.
1. Lay the planer with the base plate (3) facing upwards;
2. Turn the roller until the bolts of one of the blades are visible;
3. Loosen and remove the blade fixing bolts;
4. Press the blade guard (15) and slide the blade retaining plate
outwards;
5. Remove the blade and sharpen it;
6. Set the blade position on the adjustment screws according to
the wear on the blade. This guarantees the cutting depth
defined in the technical data of the planer;
7. Attach the blade to the roller. Align the holes of the blade
and adjustment screw with the groove and the holes of the
roller respectively;
8. Fit the blade fixing plate and tighten the screws;
9. Turn the roller 180° and repeat the procedure for the other
blade.
After the blade's installation and before using the power
tool, test it at full speed at no load for a while. Check for
misalignment of the blade or any other condition that may
affect the power tool's operation. Check that all moving parts
rotate smoothly, without abnormal noises.
Parallel guide
1. Fit the parallel guide (1) into the fixing bracket (2);
2. Insert and tighten the parallel guide fixing bolt (12);
3. Fix the parallel guide bracket to the planer and tighten the
bracket's fixing bolt (4).
The parallel guide can be installed on both sides of the
planer.
Rebate depth guide accessory
1. Fit the rebate depth guide accessory (17) to the planer;
2. Insert and tighten the fixing bolt (16) of the rebate depth
guide.
The rebate depth guide must be installed on the right side
of the planer.
Dust and shavings collection bag
Use the dust and shavings collection bag to keep the work
surface clean.
1. Fit the collection bag to the dust and shavings outlet port
(15).
Never attempt to remove the collection bag or any object
that is obstructing while the blades are rotating.
OPERATING INSTRUCTIONS
The power tool is designed for planing wood materials (such as
beams and boards), make notches or chamfering edges.
While operating the planer, you should take into consideration
some procedures:
▪ Always ensure that the planer is switched off before plugging
in the power cord and during transport. If you have the
"ON/OFF" switch pressed when connecting the power cord
or carrying the planer, accidents and injuries to the user may
occur;
▪ Never hold a workpiece with your hands or use your legs as
a support while you are working. Secure the workpiece on a
stable and completely stationary surface;
▪ Hold the appliance with both hands, one on the handle and
the other on the depth adjustment knob;
▪ Ensure that the blade guard is always fitted;
▪ Make sure there are no obstructions on the surface to be
worked on;
31
Publicidad
