Vortice CA WE Manual De Instrucciones página 11

ENGLISH
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not use
it and contact Vortice immediately
• If the appliance does not function correctly or
develops a fault, contact Vortice* immediately.
Ensure that only genuine original Vortice spares are
used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked by Vortice immediately.
• The appliance must be installed by a professionally
qualified electrician.
• The mains power supply to which the units are
connected must comply with current laws.
• The appliance is double insulated and therefore does
not need to be earthed.
• Check that the electrical power supply/socket
provides the maximum electrical power required by
the appliance. If it cannot do so, arrange for a
qualified electrician to make the necessary
modifications.
• Switch off the appliance at the installation's main
switch:
- if the appliance does not function correctly;
- before cleaning the outside of the appliance;
- if the appliance is not to be used for any length of
time.
• Ensure that the room has an adequate source of
fresh air to ensure correct appliance operation. In the
event that other non-sealed combustion based
appliances such as water heaters, gas stoves, etc.)
are installed in the same room, check that air
replacement is sufficient for all appliances to work
effectively together.
• The appliance cannot be used to control water
heaters, room heaters, etc.; neither must it exhaust
into the hot air flues of such appliances.
• Ensure that the appliance discharges directly to the
outside.
• The flow of air or fumes to be carried outside must be
clean (that is free of grease, soot, chemical and
corrosive agents, and explosive or flammable
mixtures).
• Keep the appliance's outlet grille free to ensure an
optimum flow of air.
• Specifications for the power supply must correspond
to the electrical data on data plate A (fig.1).
An omnipolar switch with a
•
contact opening distance of 3
mm or higher
provided
enabling
disconnection under overvoltage
category III conditions.
Products equipped with single-
•
phase wiring
should
for installation,
complete
(M) engines
ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines. Any
kind of modification shall be
considered
tampering and shall nullify the
relative warranty.
No specific
•
necessary
operate at nominal frequencies
without a preliminary setting.
• Thermal protection devices:
- Manual reset thermal protector
The following models are equipped with a manual
reset thermal protector
If the thermal protector is triggered, please contact
qualified personnel or Vortice authorised
Technical Assistance Centre.
If the problem persists after the reset
operation, check the electrical system to which the
unit is connected. In this case, please contact a
Vortice authorised Technical Assistance Centre or
professionally qualified personnel.
* Or an authorised Service Centre if you are outside
the Uk-Ireland territory.
be
as product
adjustment
as the devices
is