Housing; Drip Tray And Collecting Tray; Dispensing Unit, Beer Tap And Beer Hose; Storage - Clatronic BZ 3740 Manual De Instrucciones

Dispensador de cerveza
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 29
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The dispensing unit is not dishwasher-safe.
Clean the appliance prior to initial commissioning and after
each use.
In order to keep the quality of the dispensed beer at a
consistently high level, it is important to clean the dispenser
thoroughly.

Housing

1. Empty the tank completely. (Refer to chapter "Water
Change").
2. Use a clean cloth to wipe the tank.
3. Clean the lid and the exterior of the housing with a damp
cloth. You may add some manual washing-up liquid to
the cloth.
4. Use a cloth for final drying.

Drip Tray and Collecting Tray

1. Remove both the drip tray and the collecting tray from
the appliance.
2. Pour the accumulated beer into a sink.
3. Clean both components with hot water. If required, you
can add some manual washing-up liquid to the rinsing
bath.

Dispensing Unit, Beer Tap and Beer Hose

For this procedure you will need the cleaning balloon,
the cleaning hose, a container that holds about 2 litres of
clean, warm water and an empty container the water will be
drained into.
If a problem occurs, it is often just a small matter. Before contacting our customer service, please note the following:
Problem
Possible cause
The appliance does
The appliance is not connected to mains power.
not work.
The appliance is defective.
BZ3740_IM
1. Place the empty container underneath the beer tap.
2. Fill the cleaning balloon with the warm water.
3. Connect the dispensing unit to the beer hose. The click
connection must audibly engage.
4. Plug the cleaning balloon onto the end of the keg tap.
5. Use one hand to open the tap. Use your other hand to
hold and press the cleaning balloon. Pump all the water
from the balloon through the dispensing unit and the
beer tap.
6. Repeat this procedure several times.
7. Remove the dispensing unit from the beer hose.
8. Disassemble the dispensing unit into its 3 components.
To do this, turn the keg tap and remove it from the fitting.
9. Clean these components under running warm water.
Thoroughly rinse the keg tap.
In order to clean the beer tap with the beer hose but without
the dispensing unit, proceed as follows:
1. Connect the cleaning hose with the balloon.
2. Attach the cleaning hose to the tip of the beer hose.
3. Use one hand to open the beer tap. Use your other hand
to hold and press the cleaning balloon. Pump all the
water from the balloon through the beer hose.
4. Repeat this procedure until the beer hose is clean.
• Clean the appliance as described and let it dry com-
pletely.
• We recommend that you store the appliance in its
original packaging when it is not to be used for a longer
period.
• Always store the appliance at a well ventilated and dry
place outside the reach of children.

Troubleshooting

Solution
Check the wall outlet with a different appliance.
Insert the plug properly in the wall outlet.
Check the fuse.
Contact our service or a repair centre.

Storage

07.03.19
49

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido