CruxCare C2 Manual Del Usuario página 6

4. Instructions for use
CruxCare C2 Pager, product code CCPAG02
Status LED
Device indicator LEDs.
Pair with (up to)
3 devices.
Volume, Connect and
Stop buttons
Unpacking
Switch on the C2 Pager by moving the button on the side from "OFF" to "ON". If
you purchased a CruxCare kit, all accessories have been connected to the C2
Pager at the factory. Your system is ready for use.
Setting notification sound
The C2 Pager offers a selection of 3 tones. Press the "VOLUME" button to toggle
between these options:
1. Low volume tone with vibration alert.
2. No tone (silent), but with vibration alert.
3. High volume tone with vibration alert.
Notification sounds
In general
When a call button or sensor is activated, the C2 Pager will vibrate and produce
an alert tone (not in silent mode). The "DEVICE" indicator LEDs will indicate
which device caused the alert, and the respective status LED will blink red until
pressing "STOP" on the C2 Pager. Also, the C2 Pager will continue to vibrate as
long as the "STOP" button is not pressed.
4
ON / OFF switch
Belt clip