Kärcher ICC 2 Euro 3 Manual Del Usuario página 38

Emptying the water separator of the fuel
system
Raise waste container.
Insert the hose on the drain screw.
Turn the drain screw by one rotation.
Keep a suitable catch bin ready.
Close the release screw.
Cleaning and replacing the fuel filter
Raise waste container.
Loosen the fasteners of the air filter cas-
ing.
Remove covering lid.
Remove and clean the filter cartridge.
Insert new filter cartridge, if required.
Clean the screw cap.
Replace the screw cap and clamp it.
Fix the fasteners of the air filter casing.
Greasing the bearings
Grease the left end right lubrication nip-
ples of the front axle.
Grease the left end right lubrication nip-
ples of the rear axle.
38
English
Grease the lubrication nipple at the
swivel joint.
Grease the lubrication nipple at the
steering cylinder.
Grease the lubrication nipple at the
steering cylinder.
Greasing the brush-system
Grease the lubrication nipple at the
brush-system (8x).
Only 4-brush system:
Lift the covering flaps at the swivel
heads.
Grease the swivel joints (8x).
Only 4-brush system:
Lift the covering flaps at the swivel
heads.
Grease the swivel joints (8x).
Central lubrication unit (accessory)
The central lubrication unit automatically lu-
brications all the lubrication points at speci-
fied intervals.
Note
It is necessary to do an additional round of
greasing after the appliance has been
cleaned thoroughly.
Press the button on the central lubrica-
tion unit.
The central lubrication unit will not lubricate
the brush-system.
Checking the V-Belt
Check the V-Belt of the spray-water
pump for damage and wear and tear.
Raise waste container.
Check the V-Belt of the lighting system
for damage and wear and tear.
Refilling wiper water
Refill water for the wiper.