Aqua Optima Liscia Manual De Uso página 4

READ ALL INSTRUCTIONS BEFORE USE AND SAVE THEM
EN
FOR FUTURE REFERENCE
WARNING
This product is intended to filter tap water only. Do
not put water of unknown quality or that has been
microbiologically contaminated into the product.
BEFORE USING THE FILTER JUG FOR THE FIRST TIME
1. Remove all packaging from the jug.
2. Remove the lid from the jug and wipe it with a clean
damp cloth.
3. Remove the inner vessel and wash it thoroughly.
PREPARING THE WATER FILTER CARTRIDGE
1. Remove all packaging from the filter cartridge. There
may be a small residue of black carbon particles in the
bag or on the surface of the cartridge; this is normal.
These particles are harmless and are washed off during
the preparation process.
2. Soak the cartridge in a bowl of water for 5–10 minutes
to remove all the air bubbles (1).
3. Rinse for 1 minute under a running tap (2).
4. The filter cartridge is now ready for use.
FITTING THE FILTER INTO THE INNER VESSEL
1. Place the inner vessel back into the filter jug.
2. Fit the filter cartridge into the inner vessel and press
firmly down to ensure a tight seal (3).
3. Once the inner vessel is back in the jug, refit the lid
and fill the inner vessel with cool water and allow it
to pass through the filter. Once it has been filtered,
discard the water. Repeat the procedure once more
(4).
4. Fill the inner vessel for a third time, your water filter
jug is now ready for use (5).
This system has been tested according to NSF/ANSI 42 for reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less
than or equal to the permissable limit for water leaving the system, as specified in the standard.
Substance
Chlorine
The RJXXXX has been tested and certified by WQA against NSF/ANSI 42 for the reduction of
chlorine, taste and odor, NSF/ANSI/CAN 372 for lead free compliance and CSA B483.1
Rated service flow 1.34 gallons/day
While testing was performed under standard laboratory conditions, actual performance may vary.
Do not use with water that is microbiologically unsafe or unkown quality without adequate disinfection before or
after the system. Min temp 5�C/41�F. Max temp 28�C/82�F. No warranty is made for use with water outside of
these temperatures.
Manufacturers Limited Warranty
The device has a one year manufacturers limited warranty.
REPLACING THE FILTER CARTRIDGE
• The filter lifetime is approximately 50 gallons of
filtered water, which represents about a month of
normal use.
• Remove the lid and lift out the inner vessel.
• Hold the inner vessel and pull the cartridge out.
• Prepare and insert the new cartridge as described
above.
FOR BEST RESULTS
• To prevent the filter from drying out, it should not
be left unused for long periods. If such an extended
period is anticipated (such as a holiday), then it is best
to remove the filter and store it in a sealed plastic
bag. The filter can then simply be prepared as per the
original fitting instructions. Refer to Preparing the
water filter cartridge above.
• Store the filter jug in the refrigerator or in a cool
place. It is important to store the jug out of direct
sunlight and away from heat sources.
• Wash and rinse the inner vessel and jug regularly. The
lid should be wiped clean with a damp cloth.
• Use only cold or room temperature water for filtering.
• Only use mild cleaning agents, never solvents or
corrosive chemicals. Never use abrasive pads on this
product.
• Do not use the filter jug for any other purpose than
for filtering water.
Influent challenge concentration
(mg/L)
2.0 ± 10%
Maximum permissable product
water concentration
≤50%