Klarstein TOMAHAWK Manual De Instrucciones página 29

• Keep small children and pets away from the grill at all times.
• Never place the grill on tables or similar.
• Do not use the grill in very strong winds.
GAS CONNECTION
The gas connection line between the gas pressure regulator and the grill can be made
using metal bellows or a gas-approved rubber hose with a maximum length of 1.5 m.
Gas grills that run on liquefied petroleum gas (LPG) should be connected with a gas
approved rubber hose.
• If a rubber hose is used, a universal air inlet fitting is required.
• The two ends of the gas hose are connected to the grill and the gas valve
respectively. Please install the rubber hose adapter directly on the main gas pipe
without any adapters in between. The diameter of the gas hose is 8-10 mm and
varies depending on the adapter used. If in doubt, ask your local gas dealer which
adapter and gas hose is compatible with the gas bottles available in your country.
Never operate the device if you have any doubts about compatibility or if you are
unsure whether the connection is properly insulated.
• Only approved gas hoses and regulators may be connected to a (refillable) gas
cylinder. All components should comply with local regulations.
• Make sure that the gas hose is not twisted, kinked or bent by other objects. After
installation is complete, a gas leak detection (leak test) should be performed.
• Do not expose the gas hose to high temperatures.
• It is recommended that an annual air tightness test be carried out on the gas grill.
• Before each use, make sure the rubber hose is in good condition. Replace it if it
shows signs of wear or cracks.
Gas connection
with Type E adapter
If a rubber hose is being used, please
install the appropriate adapter (see
image above) directly on the main gas
pipe without any adapters in between.
Gas connection
(France)
When using the gas grill in France,
please ensure that the appropriate
adapter (see image above) is
connected to the main gas line.
EN
29