Petsafe PBC17-13338 Manual Del Producto página 7

4. Check the tightness of the Bark
Control Collar by inserting one
finger between the strap and the
dog's neck (C). The fit should be
snug but not constricting.
You should not make the collar any tighter than is required for
good contact. A collar that is too tight will increase the risk of
pressure necrosis in the contact area.
5. Allow your dog to wear the collar for several minutes, then recheck the fit.
Check the fit again as your dog becomes more comfortable with the Bark
Control Collar.
6. Trim the collar as follows (D):
A. Mark the desired length
of the collar with a pen.
Allow for growth if your dog
is young or grows a thick
winter coat.
B. Remove the Bark Control
Collar from your dog and
cut off excess.
C. Before placing the Bark Control Collar back onto your dog, seal the edge
of the cut collar by applying a flame along the frayed edge.
ON/OFF Battery Module
The PetSafe Vibration Bark Control is packaged with the battery module installed
®
in the "OFF" position. To activate the collar, use a coin to turn the Battery Module
anti-clockwise until the arrow lines up with the "ON" position. If the collar is not
going to be used on the dog immediately leave it in the "OFF" position.
C
D
petsafe.com 7