Publicidad
EN
INFORMATION
BEFORE ASSEMBLY
Choose your site carefully before beginning assembly.
•
•
• •
The ground surface must be perfectly flat and leveled and have a solid base such as concrete, asphalt,
deck etc.
Sort the parts and check against the content parts list.
• •
• •
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they do not get lost.
• •
Please consult your local authorities if any permits are required prior to constructing the product.
This product requires minimum of 0.5m surrounding the swimming pool.
• •
IMPORTANT RECOMMENDATIONS AND GENERAL INFORMATION
•
•
During assembly use a soft surface below the parts to avoid scratches and damages.
It is imperative to change any damaged item or set of items as soon as possible.
• •
Use only parts supplied by Palram - Canopia.
• •
Hardware: stainless steel, aluminium and Nickel zinc coating screws.
• •
Internal angle brackets: stainless steel and aluminium.
• •
• •
Aluminium
structure.b
•
•
This product is painted based on QUALICOAT standard.
Make sure the anchoring ground holes are clean with no dirt.
• •
Please read these instructions carefully before you start to assemble this product .
• •
Please carry out the steps in the order set out in these instructions.
• •
• •
Keep these instructions in a safe place for future reference.
Please Note: Anchoring this product to the ground is essential to its stability and rigidity.
• •
It is required to complete this stage in order for your warranty to be valid.
• •
Tighten all screws at the end of assembly.
DURING ASSEMBLY
During assembly, you will encounter different icons for different products.
•
•
Please see below for more information:
During assembly you will encounter the information icon, please refer
• •
to the relevant assembly step for additional comments and assistance.
You may use silicone lubricant spray on the frame in order to help you slide the
• •
panels into the profiles. Do not spray the Polycarbonate panels themselves.
SILICONE
LUBRICANT SPRAY
• •
Use a rubber mallet if necessary.
Make sure you remove covering plastic film from both sides of the panel.
• •
• •
All panels with the stamped words "THIS SIDE OUT" must be facing out to
achieve full UV protection. Remove plastic sticker as panels are locked in place.
Publicidad
