Emptying the dust container
•
The dust container (5) should be emptied at regular intervals to maintain good suction
force.
•
Detach the dust container from the motor unit (see the "Attaching and Detaching
Accessories" chapter, "Removing and Inserting the Dust Container" section).
•
Hold the dust container over an open dustbin.
•
Slide the catch (7) for the bottom � ap of the
dust container (6) downwards. The bottom
of the dust container will open and the dirt
will fall out.
•
Then � ip the bottom � ap of the dust
container shut again. The fastener must be
heard to engage in place.
•
Reattach the dust container to the motor
unit.
Cleaning the � lter
•
Detach the dust container from the motor unit (see the "Attaching and Detaching
Accessories" chapter, "Removing and Inserting the Dust Container" section).
•
Empty the dust container (see above).
•
Turn the lid of the dust container
anticlockwise and remove it.
•
Carefully remove the cyclone � lter (E) from
the dust container.
•
Remove the foam � lter holder (F) from the
cyclone � lter.
•
Remove the foam � lter (G) from the � lter
holder.
Please note: The thin fabric � lter is � rmly
attached to the � lter holder and cannot be
taken out of the holder!
GB
53