IKEA VAPPEBY Serie Manual De Instrucciones página 11

Getting started
Connect a USB-C cable to the input port and the other end to a power
source (a computer or a power supply) to charge your product before the
first use and whenever the LED is flashing red to indicate a low battery.
When charging, the LED light will remain solid red if the speaker is off
and will turn off when the battery is fully charged.
Recommended power supply:
5.0 VDC, 1.0 A (Not included)
Speaker functions
Turning On/Off
Press and hold the Power button (1) to turn your speaker On/Off.
Play/Pause
A short press on the Power button will play or pause music.
Auto-off
If the speaker is not paired to any device, it will turn off automatically
after 5 minutes. If the speaker is paired but no music is playing, it will
turn off automatically after 20 minutes.
Bluetooth pairing
To pair your speaker to a source device, the speaker must be in Bluetooth
pairing mode. To pair, open the Bluetooth setting on your source device
and connect to "VAPPEBY Portable".
The speaker will enter Bluetooth pairing mode automatically the first
time it is powered on, and any time that a previously paired device
cannot be found.
Factory reset
To remove previous Bluetooth pairings, reset the speaker by pressing
and holding the button (1) for more than 5 seconds. Successful factory
reset is confirmed by the LED flashing red and with an audible sound.
Alternatively, go to the Bluetooth menu on your source device and
unpair.
11