Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for use Rotaplex Visign RT3 / RT5
GB
E
Assembly steps
Bowden wire length
725mm:
The pipe must be
inserted at least 15 mm
into the sleeve and the
drain casing.
Push sliding ring and
wedge seal onto the
drainage elbow. Screw
the drainage elbow onto
the odour trap using the
union nut.
p Align the odour trap and
connect to the waste-
water system.
F
Equipment set
Turn rotatable collar to
the right (open position).
Hold rotatable collar
tight and insert valve
cone.
Turn the rotatable collar
to the right, valve cone
open.
G
Removal of equipment set
Remove rotatable collar
in axial direction.
H
Setting jet control
Water jet setting at the
jet control.
Bowden wire length
1070mm:
The pipes must be
inserted at least 15 mm
into the sleeve and the
drain casing.
Connect the water
inlet to the connecting
adapter.
q Check the drain fitting
for leaks after assembly.
Mount flange cover,
rotatable collar, valve
cone and cover plate.
Pry out and remove the
flange cover at the inser-
tion point.
32
Cut the drain elbow if
the wastewater pipe
should only have a
diameter of 40 mm.
Insert the connecting
adapter with the
mounted water inlet all
the way into the over-
flow fitting until it makes
a clicking noise.
Turn the rotatable collar
to the left, valve cone
closed.
Publicidad
