cecotec 3D ForceAnodized 550 Manual De Instrucciones página 13

WARNING: do not come into contact with ejected steam.
Dry ironing
• The steam iron can operate with or without water in the water tank. In case the iron is
operated in its dry mode, make sure the water tank is empty.
• Turn the steam controller to the minimum position "0".
WARNING: if the iron has been used during more than 10 minutes and is hot, do not pour in new water
until the appliance has cooled down.
Steam burst
• The steam-burst function generates additional steam in order to remove stubborn wrinkles
and can be activated just by pressing the steam-burst button.
Note: to prevent the soleplate from leaking, do not keep the steam-burst button pressed for
more than 5 seconds.
Note: for optimal steam burst, do not press the steam-burst button more than 3 times in a
row to prevent the iron from cooling.
Vertical steaming
1. Make sure there is enough water in the water tank.
2. Stand the steam iron on its heel rest on an iron-safe surface and connect it to the power
supply.
3. Turn the temperature knob and steam controller to maximum.
4. Hold the iron vertically and press the steam burst button, an intense steam will be ejected
from the soleplate.
Self cleaning
• Fill the water tank up to the maximum mark and close it.
• Set the temperature knob to maximum.
• Connect the appliance to the power supply.
• Holding the iron horizontally over the sink, turn the steam controller to the maximum position
and press the self-cleaning button.
• Boiling water and steam will be ejected from the soleplate's holes, taking out all impurities.
• Repeat this process if considered necessary.
Anti-drip function
• This function prevents water from spilling and avoids blotches from appearing on the fabrics
when ironing at low temperatures.
ENGLISH
3D FORCEANODIZED 550
13