Publicidad
MISUSE
Do not use the unit for:
-
Suctioning of liquids of any kind;
-
Vacuum flammable, explosive, corrosive,
toxic substances.
-
Vacuum hot substances.
Do not use the equipment in hazardous en-
vironments.
PrePArAtION OF
EQUIPMENT
Control filter systems
-
Release the lever (1 Fig.1) and remove
the cover (2 Fig.2) completely, along with
the fleece filter bag (3 Fig.2).
-
Remove the cloth dust bag (4 Fig. 3) and
check that the cartridge filter (5 Fig. 4) is
mounted inside the unit.
-
Replace the cloth filter (4 Fig. 3), replace
the fleece filter bag (3 Fig.5) on the cover
(2 Fig.5) and hold it in place to replace
the cover (2 Fig.6) engaging the groove
(6 Fig..7) formed on the cover plate (7
Fig.7) placed on the body.
-
Lock the lid by the handle (1 Fig.1).
Assembling of pipes
-
Insert the sleeve (8 Fig.8) hose supplied
in the air intake hole (9 Fig.8).
-
Attach the rigid extensions to the ergo-
nomic handle (10 Fig.9) of the hose (11
Fig.9).
-
Attach to the rigid extension (11 Fig.9)
the wanted accessory (suction nozzle,
dusting brush, crevice tool, etc. ..)
Placing electric cable
(for 230 V model)
-
Form a ring with the with the electric ca-
ble and attach it to the support (12 Fig.10)
positioning it as shown in figure 10.
Before recharging the batteries
(for Model 24 V)
Remove the charger and the battery from the
pack.
-
Plug the cable (13 Fig.11) to the battery
(14 Fig.11).
-
Connect the charger to the socket.
(15 Fig.11).
NOTE:
After connecting the power cable (15 Fig. 11)
before connecting the cable (13 Fig.11) to
the battery (14 Fig. 11) the charger WON'T
WORK.
-
On the charger (15 Fig. 11) the „green"
led will blink twice (16 Fig. 11) indicating
proper functioning;; then, the red led will
turn on (17 Fig. 11) or the yellow one (18
Fig. 11) depending on the battery's condi-
tion.
-
When the charger light turns greeb (16
Fig. 11) the batteries are charged.
NOTE:
Do not leave the cable (13 Fig. 11) connected
to the battery with the network cable discon-
nected from the charger; the batteries may
discharge and could be damaged.
Installing the batteries
(for 24V model)
-
Check if the switch (27 Fig.16) is on posi-
tion "0".
-
Place the battery (14 Fig. 12) on the de-
vice by inserting the contacts (19 Fig. 12)
in the wholes (20 Fig. 12).
-
Press the battery (14 Fig. 13) down until
you here a coupling „CLICK".
EN - 7
EN
Publicidad
