Prexiso X2 Manual De Empleo página 5

8.3 Clear key
"
Undo the most recent action by pressing key
6 briefly.
8.4 Adjusting the measuring
plane
See drawing F - H:
Rear measuring plane is the standard setting.
"
For measurement from front edge, press key
7 briefly.
"
For measurement from rear edge, press key 7
briefly again.
8.5 Unit setting
Metric system is the standard setting.
"
To change the unit, hold key 7 for several
seconds.
With every keypress, the device switches to the
next unit.
Possible units:
!
meters with mm display
!
feet inch fractional
!
summary row up to 1/16 inch
!
second row up to 1/8 inch
!
inch fractional
!
summary row up to 1/16 inch
!
second row up to 1/8 inch
9 Measuring
9.1 Measuring single distances
"
Press key 4 briefly.
"
Aim active laser at target area.
"
Press key 4 briefly.
The device measures the distance.
The device displays the result immediately.
9.2 Continuous measuring
See drawing J:
This function enables distances to be staked out.
"
Hold key 4 for several seconds.
Continuous measuring starts.
"
Press key 4 briefly.
Continuous measuring stops.
The value last measured appears in the summary
row.
LCA 762992
10 Functions
10.1 Add/Subtract
Add:
"
Measure the first distance.
"
Press key 8 once.
The device adds the second measuring result
to the first measuring result.
"
Measure the second distance.
Subtract:
"
Measure the first distance.
"
Press key 8 twice.
The device subtracts
measurement result
measurement result.
"
Measure the second distance.
Repeat if required. The device displays the result
in the summary row and the previous value in
the second row.
10.2 Area
See drawing I:
"
Press key 5 once.
The area symbol appears on the display.
"
Press key 4 and measure the first distance.
(e.g. length).
"
Press key 4 and measure the second
distance.
(e.g. width).
The device displays the result in the summary
row and the respective measured distance to the
next measurement in the second row.
10.3 Room volume
"
Press key 5 twice.
The volume symbol appears on the display.
"
Press key 4 and measure the first distance
(e.g. length).
"
Press key 4 and measure the second distance
(e.g. width).
"
Press key 4 and measure the third distance
(e.g. height).
The device displays the result in the summary
row and the respective measured distance to the
next measurement in the second row.
10.4 Pythagoras
See drawing K:
"
Press key 5 three times.
The Pythagoras symbol appears on the
display.
"
Press key 4 and measure the first distance
(diagonal measurement).
the second
from the first
10/144