CONTENTS:
Section 1. lnstallation
Section 2. Safety Advice
Section 3. Operating the Appliance
Section 4. Maintenance
Section 1. lnstallation
IMPORTANT! This appliance must be left to stand in an upright positi-
on for at least 4 hours before being switched on for the first time.
This appliance has been designed for Domestic Use Only.
Remove all packaging and securing tape from the appliance.
Wash the interior of the appliance with luke warm water containing a
small amount of bicarbonate soda (5ml to 0.5 litres of water).
Position the appliance in a dry atmosphere and out of direct sunlight.
Do not position next to a cooker or other sources of heat, i.e. radiator.
This appliance should not be sited in a cold atmosphere, i.e garage or
shed. Doing so may cause the freezer unit to underfreeze.
lf positioned next to another fridge or freezer, leave a mínimum gap of
2cm between the appliances in arder to avoid condensation.
A clearance of 50mm should be left above the appliance. lf this cannot
be achieved you should ensure a clearance of 25mm is maintained on
each side of the appliance.
Fit the plastic wall spacers to the condenser on the rear of the applian-
ce, this will ensure an air gap between the appliance and the wall.
Do not place or store heavy items on the top of this appliance.
Ensure that the appliance is positioned on a firm flat floor.
This appliance must be level. Adjust the level by screwing the adjusta-
ble feet up or down (use your fingers or a suitable spanner).
Ensure that the appliance is upright and both feet are in firm contact
with the floor so that the cabinet is stable.
Connect the plug to an adjacent 13amp socket out let and ensure that
the appliance is not standing on the supply cable.
6
V.2