Chasing Sediment Sampler Manual Del Usuario página 3

CHASING Sediment Sampler
EN
User Manual
CHASING Sediment Sampler is a dedicated accessory for CHASING Grabber Arm 2.
Its simple and easy replacement mode and intelligent grip control system make the
accessory more helpful for exploring unknown underwater areas.
Instructions on the Replacement, Installation
and Use of Tool Head
①Turn the right wave wheel on the right to open the original tool head to the
maximum, ②Remove the thumb screw, ③Remove the Two-jaw Clamp before
you replace it.
Right wave wheel
03
1. Sediment sampler
2. Mounting port of the sediment sampler
3. Thumb screw
① Insert the sediment sampler into the middle shaft at the front end of the grabber claw,
2.
② Tighten the thumb screw to complete the installation.
*Note: When there is no tool head installed on the grabber claw, if you need to
install a tool head, turn the right wave wheel to extend the middle shaft to the
front end, then install the tool head.
Specifications
Maximum opening of the Grabber Arm 2
Maximum gripping force
weight
Maximum diving depth supported
Dimensions
Notes
1) Before using the remote controller to control the grabber claw, press and hold the
button on the rear-right (with the grabber claw icon) or enable the grabber claw
function in app settings.
2) When installing the tool head of grabber claw, you need to extend the middle
shaft to the front end by using the remote controller before installing the bucket.
3) Make sure the ROV is powered off before you install and connect the grabber
claw.
4) Check the ROV and make sure the ports are dry and clean before use. Salt and
moisture may corrode the port. If there are water droplets in the port, be sure to
flush the port with fresh water, and then use a paper towel or cotton ball to absorb
the water in the port.
EN
170 mm
7 kg
325 g
100 m
178 × 120 × 85 mm
04