Bond 66'' Manual Del Usuario página 7

HANGING THE FAN
Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove ball pin; remove
ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing
2
with the mounting collar (where the wires come out) facing
upward.
Loosen the two security set screws and remove the downrod
3
pin and retaining clip from the coupling on top of the motor
assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable from
4
the fan through the downrod. Thread downrod into coupler
until holes align. Insert downrod pin through holes in
mounting collar and downrod; clip cotter pin through small
hole in end of downrod pin to hold downrod in place.
Tighten security set screws against downrod using a large
5
flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
Cross pin
Hanger
ball
Set screw
Fig. 1
Hook-up
(3) Wires
Downrod
Security Screws
Mounting Collar
Cotter Pin
Top of
Fan Body
Fig. 2
Downrod
Safety Cable
Downrod Pin