Connecting To A Gas Supply; Gas Cylinder Requirements; Installing A Gas Cylinder; Disconnecting A Gas Cylinder - Pit Boss SPORTSMAN PB2BSPD Manual Del Propietário

Tabla de contenido

Idiomas disponibles

GAS CYLINDER REQUIREMENTS

The griddle is set and tested with liquid propane gas only. When purchasing a gas cylinder for use with this unit, ensure it meets

the following requirements: 0.45 kg (1 lb) / 19.6 cm (7.75 in) capacity, only marked "PROPANE", constructed and marked in accordance

with Specifications for LP Gas Cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN\

CSA-B339, Cylinders, Spheres and Tubes for Transportation of Dangerous Goods; and Commission, as applicable (see label for marking).

This griddle has been provided with a cylinder connection device that is compatible with the griddle's regulator port.

CAUTION: It is important to inspect the cylinder connection device. Check the propane tank valve

rubber seal for cracks, wear or deterioration prior to use. A damaged rubber seal can cause a gas

leak, possibly resulting in an explosion, fire, or severe bodily harm. Do not use a propane tank with a

damaged rubber seal.

INSTALLING A GAS CYLINDER

Make sure burner control knob is turned OFF by pushing it in

and turning it clockwise to the OFF position.

2. While holding the lid handle side closest to propane cylinder

with one hand, push propane cylinder into regulator and turn

clockwise until tight.

3. For optimum performance, allow cylinder to hang vertically in

the Cylinder Wire Retainer where there is no danger of being

bumped or disturbed. Note proper positioning shown. The

cylinder angle to the horizontal plane should not be less than

20 degrees.

4. Gas cylinder is now installed.

The outdoor grill, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes

with the National Electrical Code ANSI/NFPA 70, or Canadian Electrical Code, CSA C22.1.

Do not store a spare LP gas tank under or near this appliance.

2. The cylinder supply system must be arranged for vapor withdrawal.

3. If the information in 1) and 2) is not followed exactly a fire causing death or serious injury may occur.

DISCONNECTING A GAS CYLINDER

Ensure the control knob on the griddle is completely closed by turning to the OFF position. Turn LP gas tank valve to the

CLOSED position, and allow the regulator knob to pop out.

2. Turn the cylinder counter-clockwise (by hand) to disconnect from the regulator valve opening. Replace the protective caps

on the regulator valve opening and the top of the gas cylinder for storage (if not empty).

NOTE: If storing the griddle indoors, leave the gas cylinder outdoors.

WARNING: Do not transport griddle with gas cylinder attached. The cylinder may loosen off the valve, and

cause a gas leak, possibly resulting in an explosion, fire, or severe bodily harm. Disconnect gas cylinder

first before travel or storage.