Lighting Procedure; Manual Lighting Procedure - Pit Boss SPORTSMAN PB2BSPD Manual Del Propietário

LIGHTING PROCEDURE

1. Verify that all control knobs are turned to the OFF position.
2. Connect LP gas cylinder as per instructions. Turn LP gas tank valve to OPEN.
3. Note the indicator marker on the control knob. Push and hold down the control knob on the griddle and turn 90 degrees
(or 1/4) counter-clockwise SLOWLY (2 to 3 seconds) to HIGH. You should hear a "click" sound to indicate a spark from the
igniter, and look for flame to ensure the burner is lit. If it does not, repeat up to three times.
4. If ignition does not occur in 5 seconds, turn the control knob to OFF, wait 5 minutes and repeat lighting procedure. If the
above points do not work, follow Manual Lighting Procedure instructions .
5. After the burner has caught fire, you are ready to enjoy your griddle at your desired temperature!
If the burner goes out during operation, turn the control knobs to the OFF position. Wait five minutes
before attempting to relight to allow any accumulated gas to dissipate.
IGNITER FAILURE PROCEDURE
If for any reason your igniter fails after three of four attempts, check the following steps, or start your griddle
using the manual method.
1. Ensure the control knobs are turned to the OFF position. Allow any accumulated gas to dissipate.
2. After five minutes, check the following:
• Visually confirm that the igniter is working by pushing the igniter button and looking at the igniter tip for a
spark. If no spark, adjust the distance between the igniter (electrode) tip and burner to 4.5 mm (3/16 in).
• Visually confirm that the burner tube and portholes are not obstructed. If blocked, follow Care & Maintenance
instructions .
3. If the above points do not work, follow Troubleshooting instructions .

MANUAL LIGHTING PROCEDURE

1. Verify that the control knob is turned to the OFF position.
2. Connect LP gas cylinder as per instructions. Turn LP gas
tank valve to OPEN.
3. Note the indicator marker on the control knob. Push in
the regulator knob and turn 90 degrees (or 1/4) counter-
clockwise to HIGH.
4. Quickly and carefully, use a lit match secured with the
lighting rod (included with the grill) to light burners.
Access the burners through the cooking grid and hot plate.
Position lit match near side of burner. Do not attempt to
light another area of the burner. This can cause injury.
NOTE: Do not use spirit, lighter-fluid or kerosene for
lighting or refreshing a fire in your griddle.
5. After the burner has caught fire, you are ready to enjoy
your griddle at your desired temperature!
8