eSmart MIMOTO Instrucciones De Manejo página 24

Wall mounting with
wall plugs and screws
Mounting of the canvas onto a wall is done using
the wall plugs and M6x45-screws supplied.
Measure the size of the borehole so that the wall
plug can be inserted precisely.
Now tighten the M6x45-screws. Be sure to lea-
ve a few millimeters of air between the wall and
the screw head.
Now you can hang the screen housing over the
screw heads and mount it. Now firmly tighten
the screws.
Operation
The wall controller
Press the top button to re-
tract, or the bottom key
to extend the canvas. The
„Stop" button stops the mo-
tor operation in any position.
24
Remote control
Press the top button to re-
tract, or the bottom key
to extend the canvas. The
„Stop" button stops the
motor operation in any po-
sition.
Permanently set
extension length
Via remote control
First, retract the entire screen.
1
Now, begin to extend the canvas.
2
Press the „Down" button.
If the screen has reached the
3
desired position, press the „Stop"
and „Down" buttons at exactly the same
time. You will hear a double indicating
tone. Now, when you retract the screen
completely and once more extend the screen,
it will stop permanently in this position.
Important: The remote control does not
save the position of your screen, but saves the
time that was required to reach the desired ex-
tension length. Therefore, you must not inter-
rupt the extension of the screen by pressing the
„Stop" button and then resuming extension.
up
stop
Important: If you frequently extend and re-
down
tract the screen, the motor will switch off due to
overheating and will only work again when it has
cooled to operating temperature.
up
stop
down