Publicidad
Idiomas disponibles
Idiomas disponibles
Notes:
1) Set the correct time. The on/off timer functions are based on the set real time.
2) On/off timer settings are not saved in the memory. They must be set again
after the power has been removed from the unit.
3) Both the on and off timers must be set so that the unit can operate in cycles
around the clock.
Possible errors communicated by the device:
Error code
E1
E2
E3
E4
Overload
Phase
sequence
Lack of phase
Continuous drainage of water
The machine can be placed near a sewage system to enable continuous drainage. Here
are the installation tips:
•
If the drain pipe is long enough to reach the waste water drain, there is no
need to connect an extension
If the discharge pipe is too short, prepare an extension pipe (Ø16mm) and
•
place it in the discharge pipe of the unit.
The discharge pipe must not bend or twist.
•
The end of the discharge pipe should be below the beginning of the pipe.
•
When the water tank is full, the "FULL" light will light up
•
Error description
Coil temperature sensor
malfunction
Ambient temperature sensor
error
Humidity sensor error
Low pressure or refrigerant
leakage
The compressor is not working
Wiring phase sequence error
Power phase is missing
Solution
Contact the
manufacturer
Note
-
-
-
-
-
This applies to
three-phase
power
Publicidad
