Descargar Imprimir esta página

Vortice ARIETT I Folleto De Instrucciones página 8

Ocultar thumbs Ver también para ARIETT I:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 13
ENGLISH
!
Precaution:
• Do not make any modifications of any kind to your
product.
• The appliance must not be exposed to atmospheric
conditions (rain, sun, etc.).
• The product must only be installed by a qualified
technician.
• Perform periodic inspection on the unit to see that it
is free of visual defects. If any are found, do not
operate the unit and immediately contact Vortice.
• The electrical mains to which the unit is connected
must conform to current standard.
• The appliance must not be used to activate water
heaters, stoves, etc., nor must it extract to their hot-
air ducts.
• Since the appliance is double insulated, it does not
need to be earthed.
• The electrical power source to which the product is
to be connected must be able to provide the
maximum amount of electrical power required by the
product. If it cannot do this, contact an electrician for
the appropriate remedial action.
• When installing the appliance, a multipolar switch
must be used. The switch interpole distance must be
no less than 3 mm.
• The temperature of the air or fumes being extracted
must not contain any greasy substances, soot,
chemical agents, corrosive agents, or mixtures that
are explosive or inflammatory.
• The appliance must exhaust either directly to the
outside or into a duct reserved solely for the
appliance.
• Effective appliance operation requires adequate
The power-source data must be consistent with the
electrical data shown on the nameplate (A).
8
this symbol indicates that care must be taken to avoid damaging your product
room-air replenishment. Moreover, if there is also a
water heater, gas stove, etc. drawing its air for
combustion from the same room, room-air
replenishment must be increased to allow all
appliances to work effectively.
• Do not cover or obstruct the unit's air intake and
outlet grilles .
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by a qualified
engineer.
• Should the appliance fail to operate or not operate
correctly, turn the switch to off. Contact Vortice
immediately and, if repairs are required, make sure
that original Vortice parts are used.
• Turn off your appliance when your are not using it.
• When removing the unit for storage, first turn off
the main switch, then disconnect the electrical cord
from the wall socket, and then store it in a place
which is inaccessible to children.
• The appliance must be installed so that its impeller
is out of reach on the outlet side (as determined by
the Standard Finger Test, Fig.B) in conformance
with the current safety regulations
Ariett IT (LL)
• The timer is arbitrarily factory set at the minimum
value of 3 minutes, but it can be set anywhere
between 3 and 20 minutes by adjusting the trimmer
(see fig. 26).
The unit turns on automatically a few seconds after
the light is turned on and continues operating for the
set period of time after the light is turned off.

Publicidad

loading

Este manual también es adecuado para:

Ariett it